高级检索
    吴宇晖, 张少迪, 任自忠, 王明枝. 植酸−三聚氰胺处理木材阻燃性能研究[J]. 北京林业大学学报, 2020, 42(4): 155-161. DOI: 10.12171/j.1000-1522.20190406
    引用本文: 吴宇晖, 张少迪, 任自忠, 王明枝. 植酸−三聚氰胺处理木材阻燃性能研究[J]. 北京林业大学学报, 2020, 42(4): 155-161. DOI: 10.12171/j.1000-1522.20190406
    Wu Yuhui, Zhang Shaodi, Ren Zizhong, Wang Mingzhi. Flame retardant properties of phytic acid and melamine treated wood[J]. Journal of Beijing Forestry University, 2020, 42(4): 155-161. DOI: 10.12171/j.1000-1522.20190406
    Citation: Wu Yuhui, Zhang Shaodi, Ren Zizhong, Wang Mingzhi. Flame retardant properties of phytic acid and melamine treated wood[J]. Journal of Beijing Forestry University, 2020, 42(4): 155-161. DOI: 10.12171/j.1000-1522.20190406

    植酸−三聚氰胺处理木材阻燃性能研究

    Flame retardant properties of phytic acid and melamine treated wood

    • 摘要:
      目的公共场所和住宅起火后易引燃木质材料,迅速燃烧,火势蔓延,并产生大量有毒烟气,导致人员伤亡。为了进一步提高公共场所消防安全水平,以及降低火灾危险性,需对木材进行阻燃处理。本研究用植酸与三聚氰胺处理木材,研究改性材阻燃性能,旨在为木材阻燃提供新思路,丰富木材阻燃体系。
      方法使用两步浸渍法在青杨内部浸入植酸−三聚氰胺阻燃剂,研究改性木材的增重、增容、热解与燃烧性能;分析改性材燃烧后的残炭形貌,探讨植酸三聚氰胺复配阻燃剂应用于木材的阻燃机理。
      结果与对照组相比,15%植酸与5%三聚氰胺复合处理组(PM2)的热释放速率峰值和总热释放量分别降低了91.24%和79.05%,热释放抑制效果较好;与对照组相比,PM2组显示出更好的抑烟性能,烟释放速率减少了52.94%。与P15%组相比,PM2组的一氧化碳平均产率减小了51.29%,具有明显的减毒作用。PM2组的残炭量显著提高,较P15%组提升了69.58%,与对照组相比增加了278.4%。
      结论植酸−三聚氰胺阻燃体系能够进入木材,植酸与三聚氰胺复配处理能减少阻燃木材燃烧的热释放速率、总热释放量、总烟释放量与CO产率。植酸能催化木材脱水和炭化反应,使热解反应在较低温度发生,促使木材产生较多残炭。三聚氰胺能减缓木材热解速率,植酸与三聚氰胺协同作用可促使木材生成更多残炭。

       

      Abstract:
      ObjectiveWooden materials are easy to get ignited when furniture and buildings go up in flames. It can cause the fast fire spread and produce much toxic gases leading to the human death. In order to reduce the fire hazard of furniture and buildings, wood must be treated for fire retardancy. In this study, an intumescent flame retardant (IFR) system of phytic acid and melamine was prepared and used as a flame retardant of wood, the flame retardancy of the treated wood was then investigated. The purpose of this paper is to provide a new thought and enrich the IFR system.
      MethodTwo-step impregnation method was conducted to assemble the phytic acid-melamine flame retardant in the interior of Populus cathayana. The weight percent gain, bulking, pyrolysis and combustion behavior of the modified wood was assessed. The morphology of the residue of treated wood after combustion was analyzed in order to discuss the mechanism of phytic acid-melamine IFR system.
      ResultThe first peak of heat release rate and the total heat release of 15% phytic acid and 5% melamine treatment group (PM2) were reduced by 91.24% and 79.05% compared with that of control, respectively. The PM2 group showed stronger smoke suppression performance, and reduced the total smoke emission by 52.94% compared with the control group. The mean carbon monoxide yield of PM2 group was reduced by 51.29% compared with the P15% group. The amount of carbon residue of PM2 group was significantly increased, which was 69.58% higher than that of P15% group and 278.4% higher than that of the control group. The PM2 group had the optimum effect on promoting the residue and reducing the heat release.
      ConclusionThe phytic acid and melamine flame retardant system can be penetrated into the wood. The combined treatment of phytic acid and melamine can reduce the heat release rate, total heat release, total smoke release and CO yield of flame retardant treated wood. Phytic acid takes part in catalyzing the dehydration and carbonization of wood which leads to the lower temperature of degradation reaction and promotion of the formation of carbon residue of wood. The synergistic effect between phytic acid and melamine can enhance the formation of carbon residue of wood.

       

    /

    返回文章
    返回